> < practical carving machine common fault and problem analysis and solution - Engraving machine

Engraving machine common fault and problem analysis question 1: open the software, computer prompts 'open the card failed, please check card'. Solution: 1. Check the card driver have installed, or change my card by a PCI slot; 2. The two root data connections to installation, check if there is any breakage phenomenon; 3. D macro card has a problem, replace the card. Question 2: open the software prompt: three axis alarm, initialization error signals. Check the computer have two wires connected with the machine; Check control box connecting plate of the fuse is burned, change the fuse; 3. Check whether the power supply is normal power supply. Question 3: sculpture dislocation occurs, or the wrong size. Check the path of the carving software correctly or not; The clearance check screw and the screw securing the polished rod have loose; Check software parameter Settings are correct. Question 4: walking the X axis sections of Z axis when not carried knives, press the up going but going down. Check whether the Z axis motor run normally, the size of the power and drive current; Check whether the Z axis motor line have poor contact or discontinuity in the case 3. Check whether distance tool set. Question 5: spindle motor forward or backward. Check the inverter parameter setting; Pick the transducer signal whether. Question 6: hit a knife. The Z axis motor power is not enough, loose coupling; The Z axis drive current is too small, or the wrong line 3. Cable didn't answer. Question 7: open software boot and shaft appeared to shut down. Drive problem or computer output signal poor contact; Poor contact motor line. Question 8: machine no electricity when the phone is switched on. Check whether the start button line is connected and whether the button burn out; Check whether the ac contactor is short circuit or burn out. Question 9: button when motion axis to one direction only. Check whether the data line is normal, whether the data line socket inserts. Check the motor wiring for virtual welding. Question 10: send software can't normal open, graven things appear deformity. To install the new system and software; Check the X, Y axis screw and screw loose; Carving path has a problem