TS1610 Dual Heads CO2 Laser Cutter Machine Auto Feeding Fabric Laser Cutting Machine
Enclosed Type
Laser cutting machine processing effect is not ideal
by：Transon
2020-10-31
1.
Focus on location choice of laser cutting machine;
Sure good focus and corresponding location on the surface of the material becomes very important, its direct relation to the cutting quality.
Focus of power is high, and is in the position of the focus of most of the time in the location of the cutting material surface or below the surface of a little bit, when focus in a good position, small slot, high efficiency, good cutting speed can obtain good cutting result.
2. Lens is a key reason, if you want to check the lens is broken or dirt, because such a situation can lead to the laser scattering, laser beam coarsens, replacement or cleaning the lens is the only way.
3. Factors of laser tube is also cannot be ignored, and check the quality of the laser tube light mouth there out, if there is a point or points of light is not round, the phenomenon such as hollow, as the supporting point of the laser tube, the direction is right! The solution need to adjust the support, rotation, replace the laser tube.
4. The effects of cutting speed on processing quality and processing efficiency. Metal laser cutting machine processing speed too fast, easy to cause the workpiece cutting opaque, etc. , or too slow cutting debris residual and burn the edge of the phenomenon. According to the actual artifacts including adjusting parameters to try cutting thickness gauge, to achieve better cutting speed.
2. Lens is a key reason, if you want to check the lens is broken or dirt, because such a situation can lead to the laser scattering, laser beam coarsens, replacement or cleaning the lens is the only way.
3. Factors of laser tube is also cannot be ignored, and check the quality of the laser tube light mouth there out, if there is a point or points of light is not round, the phenomenon such as hollow, as the supporting point of the laser tube, the direction is right! The solution need to adjust the support, rotation, replace the laser tube.
4. The effects of cutting speed on processing quality and processing efficiency. Metal laser cutting machine processing speed too fast, easy to cause the workpiece cutting opaque, etc. , or too slow cutting debris residual and burn the edge of the phenomenon. According to the actual artifacts including adjusting parameters to try cutting thickness gauge, to achieve better cutting speed.
Custom message
Related Products
