Enclosed Type

High speed engraving and milling machine operation

by:Transon     2020-04-25
For high-speed machines, engraving and milling machine, the machine, we should especially pay attention to safety when used. Even a skilled operator cannot treat STH lightly. Here for you, a high speed engraving and milling machine operation notice: one, check the cooling liquid tank before using the coolant temperature and storage, open the refrigerator, The pump) Ensure the normal order of the cooling fluid circulation. Second, card material must be strong, must follow 'outfit, outfit are loading flat,' the principle of it is strictly prohibited in material dangling sculpt. 3, card DaoJu, must take the card head of dust and debris to clean up, and then put is the card head pressure cap screwing in the lock, then loaded on the motor shaft and insert DaoJu card first, then lock pressure cap, top and bottom knife tightness pressure cap when it is strictly prohibited to push-pull mode to a rotating way. When the first cut should be clear the card slivers, will press tool card head cap off with knives. Four, card cutter tool show card head shall refer to the length of the engraving depth, artifacts, fixture, under the condition of satisfy the conditions to show the length of the card head as short as far as possible, when the total length of the cutting tool is smaller than 22 mm, it is forbidden to continue to use. Five, the card cutter, the handle into card head must be greater than the length of the 18 mm. Six, must want to add in the metal machining cutting fluid, cutting fluid must be rushed to the cutting tool. Seven fuselage, engraving and milling machine carving process, the company is strictly prohibited too close observation of cutting surface, to prevent the chip into his eyes! Observation should pause when carving, shut off the spindle motor. Carving process, it is strictly prohibited to use hand touch cutting surface, it is prohibited to use cotton silk wipe the surface. Eight, it is strictly prohibited to place any items on the machine table or bar; It is prohibited to put your hands on, the body on the machine tool bed body. 9, it is forbidden to knock, spindle motor end cover of impact. Tapping card unloading knife when it is strictly prohibited. Ten, ban use machine in extreme heat or cold condition, when the environment temperature 10 ℃ - 30 ℃ before use. Eleven, carved machine is a kind of light processing equipment, and machining weight and loading card slivers not more than the sum of rated bearing the weight of the machine. 12, the size of the used tools should be inspected carefully before they are carving ℃ performance whether meet the requirements of processing programming. 13, carefully check before processing cutting tool path is correct. 14, be sure to confirm again before start processing - axis each cutting point is correct. Fifteen, must let the spindle motor rest two hours a day.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
88888888888888888888888