medical mask

High-speed CNC engraving and milling machine in use to do what work?

by:Transon     2020-04-23
High-speed CNC engraving and milling machine for precision numerical control equipment, when used in the daily must do a good job in the following respects of remember that cannot be used blindly, so as to avoid can cause damage to the machine. 1, high-speed CNC engraving and milling machine running time under 10 hours a day in a row, guarantee the normal work of the cooling water clean and the water pump, must not water shortage phenomenon in a spindle motor, regular replacement of cooling water, in order to prevent the water temperature is too high. If working environment temperature is too low in winter can replace the water in the tank with antifreeze. 2, if one of three axis high-speed CNC engraving and milling machine shaft can't move, this time to check the corresponding shaft of the drive block is damaged. Inspection method can be used to replace method: will not move under the shaft of the aviation plug in other active on the shaft of the drive. 3, if after the exchange of high-speed CNC engraving and milling machine fixed axis normal running, can show that the shaft of the driving piece has been damaged, need to replace a good driver. If still won't do that cable fixed axis or replace defective cable or motor. Three axis are not move. At this time have check the three-axis air plug and control box connection is good, power control box is opened. Whether the data line and control box and control card connected to the PC host.
Custom message
Contact