Enclosed Type

The analysis of the causes of laser cutting machine light path adjustment is bad

by：Transon 2020-10-28

Laser cutting machine light path adjustment is not good, usually have the several ways: one, the guide rail base deformation, a little more than four angles road light tones. How to judge is guide base deformation. We could start with the Y direction of the light on the road to a point, and then turn around X light path to a point above. We put the laser from laser mesa four angles, the up and down or so all point to a point, did see the light in the same position, if not in the same position, which, this machine is you guide the base deformation. Second, the belt wear. When we move light, if it is found that flare up and down is always not in a position above, machine back and forth motion, light will always change, like this kind of situation, may be belt wear. Three, the gear inside a lot of stuff. If at the time of adjustable light path, upper and lower point light machine, always not in the same line above, you have to consider, if gear inside a lot of stuff. We can turn off the machine, and then hand to push bar, carefully check the belt, if there is a transfer belt surface, where it is gear inside a lot of stuff.

Custom message