Laser cutting machine safety operation

Strict requirements to comply with the safety of the laser cutting machine operation procedures. In strict accordance with the laser launcher to start the laser. Operators must be trained before the operation, familiar with equipment structure, performance, and master the knowledge about operating system. Wear labor protection articles according to the rules in the vicinity of a laser beam must wear protective glasses in keeping with the rules. In can not ascertain whether a particular material with laser or before heating don't go to the material processing, in order to avoid potential danger of smoke and steam. When the equipment is operating personnel shall not leave without authorization, if indeed need to leave should be shut down or cut off the power switch before leaving. Will put a fire extinguisher readily accessible place; When not in processing must turn off the laser or light brake; Don't without protection of laser beams with combustible. If discovery is unusual, in the process of processing should immediately stop, troubleshooting and report to supervisor in time. Keep the laser, the lathe bed and the surrounding site neat, orderly, no oil, artifacts, plank, waste stack. Use cylinders, should avoid to crush the welding wire, so as to avoid leakage accidents. The use of gas cylinders, transportation shall comply with the rules of the cylinder. It is forbidden to cylinders to sunlight or near a heat source in the sun. When you start the cylinder valves, the operator must stand in the bottle mouth side. To abide by high pressure safety procedures for servicing. 40 hours per operation or maintenance, each work 1000 hours a week or maintenance every six months, to be carried out in accordance with the rules and procedures. Pay attention to the machine running situation at work, in order to avoid the laser cutting machine out of the valid range or two collision accident