Congratulations for our clients from Austria recieved CNC Router machine
Enclosed Type
How to improve the quality of the optical fiber laser cutting machine cutting surface?
by：Transon
2020-10-30
High speed wire cutting machine in processing for 50 to 80 hours after the change should be considered conductive block cutting position or change of the conductive block, have smudgy used liquid detergent to clean.
It is important to note: when the change of position or change of conductive block conductive block, must realigns verticality of wire electrode, so as to ensure the machining accuracy and surface quality.
fiber laser cutting machine should be inspected regularly wheel rotation, if the rotation is bad it should be replaced, must also carefully check damage and smudgy degree, upper and lower nozzle with a cleaning fluid to remove dirt, injury occurs should be timely replacement.
fiber laser cutting machine should also regularly check storage wire cylinder wire, wire loss is too large will affect the machining accuracy and surface quality, should be timely replacement. In addition, conductive block, idler pulley and upper and lower nozzle adverse conditions can also cause the vibration of wire electrode, can well discharge machined surface even at this moment, but because of the wire electrode vibration, processing surface is easy to produce wave or stripe, will cause the variation of surface roughness of workpiece.
fiber laser cutting machine should be inspected regularly wheel rotation, if the rotation is bad it should be replaced, must also carefully check damage and smudgy degree, upper and lower nozzle with a cleaning fluid to remove dirt, injury occurs should be timely replacement.
fiber laser cutting machine should also regularly check storage wire cylinder wire, wire loss is too large will affect the machining accuracy and surface quality, should be timely replacement. In addition, conductive block, idler pulley and upper and lower nozzle adverse conditions can also cause the vibration of wire electrode, can well discharge machined surface even at this moment, but because of the wire electrode vibration, processing surface is easy to produce wave or stripe, will cause the variation of surface roughness of workpiece.
Custom message
Related Products
