Fine carving machine motor path does not round and use of sync!

Carved machine carving path does not round is why? How to deal with? Carved carving machine in daily sync phenomenon in the process of using the motor, we should be how to solve? A, fine engraving machine engraving path does not fruity reasons and solutions. Carved machine engraving path does not sleek is generally caused by the following two reasons: 1, the fine carving machine y or x axis clearance, may also have clearance, two axis at the same time, lead to shake in the process of carving, carving path deviation causes the lettering is not smooth. Line speed and curve 2, fine carving machine speed difference is too big, lead to carving machine in curve when the vibration is too large, the carving path deviation and appear lettering is not smooth. For fine carving machine path does not sleek problem there are two effective processing methods: 1, for the first reason, is to change the speed of a straight line or curve, change the value in carving machine and its parameters. If you don't know how to set up, can contact carved factory house. 2, for the second reason, if engraving machine is a circle, will think of some way to change guide or slider, action will be big, depending on the reason. So many of the side rail is simple, only need to adjust the up and down or before and after the slider. Second, the fine carving machine in the process of using the motor out of sync reason and solution. Motor synchronization phenomenon is mainly refers to carved machine rack Y of double motor drive structure is not synchronized, this structure carved by rack drive equipment general Y direction is to synchronize two motor running. In order to ensure that carved carving machine smooth operation and running accuracy, two motor at the time of assembly to complete synchronization can be, if you don't sync, carving machine will not be able to run normally. Why don't appear fine carving mechanical and electrical machine synchronous phenomenon? More common is the synchronous belt is loose. Synchronous belt is loose and daily maintenance and maintenance of the machine has a lot to do. If we don't usually cleared up on the rack of debris and dust, synchronous belt running to have sundry place will force suddenly become bigger, so for a long time will become loose, eventually lead to both sides of the motor is out of sync. In the setting of machine parameters, there is a 'linear acceleration parameters, for carving machine rack driving the numerical shoulds not be too big, usually set at around 300. If the parameter value is too large, machine due to start at start too fast will tooth is bad, can also lead to sync on both sides of the motor. Another step drive malfunction will cause the computer to signal distortion of stepper motor, which can lead to both sides caused by the motor running steps don't sync! If drivers appear problem, the customer to contact carved carving vendors would give the replacement, to ensure the fine carving machine running normally.