Laser cutting machine fault emergency solutions

Laser cutting machine mould is to use processing sheet metal forming tools, in the process of the development of the mould has been play an important role, but we also cannot deny, laser cutting machine mould also can appear some problems hinder the development of the mould production. Cutting machine manufacturer is here to explain some of the laser cutting machine fault emergency solutions.
1, proportion of laser cutter mold overflow valve solenoid coil is electrically, proportional solenoid coil voltage is in accordance with the requirements, if is the above reasons, please check the related electrical reason; 2, check whether the cartridge valve is stuck or the main valve core are jammed, and damping hole plug, if it is all these reasons, please remove the laser class cutter mold overflow valve is clean, put on again; 3, three-phase power supply phase modulation, causing the motor reverse; 4, check the laser cutting machine mold tank oil level is too low, liquid mouth not flooded in, and fast forward when liquid on the oil cylinder cavity suction empty cause lack of liquid. As these reasons can be the oil tank to liquid mouth more than 5 mm above the liquid hole completely flooded; 5, check whether fast-forward speed too fast, cause the lack of liquid. Such as laser cutting machine through the modification of afore-mentioned reasons can mould system parameters reduce the speed of fast forward; 6, check whether the laser class cutter mold filling liquid valve fully open, if because of the oil pollution, make the liquid valve valve core activities have not flexible card lag phenomenon caused by insufficient liquid. Need to clean the laser class cutter mold filling valve to install the valve core.