Laser cutting machine fault emergency solutions

Need to clean the laser class cutter mold filling valve to install the valve core.
mould is to use processing sheet metal forming tools laser cutting machine, and bending machine in the process of the development of the mould has been play an important role, but we also cannot deny, laser cutting machine mould will also be some questions on the block mould of fruit development. As these reasons can be the oil tank to liquid mouth more than 5 mm above the liquid hole completely flooded; Check whether fast-forward speed too fast, cause the lack of liquid.
proportion of laser cutter mold overflow valve solenoid coil is class, proportional solenoid coil voltage is in accordance with the requirements, if be this reason, please check the related electrical reason; Check whether the cartridge valve is stuck or the main valve core are jammed, and damping holes blocked, if be this reason, please remove the laser class cutter mold overflow valve is clean, put on again; Three-phase power supply phase modulation, causing the motor reverse; Check whether the laser class cutter mold tank oil level is too low, liquid mouth not flooded in, and fast forward when liquid on the oil cylinder cavity suction empty cause lack of liquid.

。 We will give you explain some laser cutting machine fault emergency solutions. Such as laser cutting machine through the modification of afore-mentioned reasons can mould system parameters reduce the speed of fast forward; Check whether the laser class cutter mold filling liquid valve is fully open, if bending machine as a result of the oil pollution, make the liquid valve valve core has not flexible flow card lag phenomenon caused by insufficient liquid.








the working principle and process characteristics of laser cutting machine