How to repair the CO2 laser engraving machine common failures

CO2 laser engraving machine compared with traditional operation, equipped with fast speed, easy to operate, easy to paint, etc, have been popular with many manufacturers. But the CO2 laser engraving machine tend to work for a long time, so failure is inevitable. Below small honour to introduce you to a common breakdown maintenance of CO2 laser engraving machine, hope for your daily help about laser engraving machine machine fault.



prompt: three axis alarm, initialization error 4



1. Check the computer have two wires connected with the machine.



2. Check whether a fuse of the control box adapter plate burning, change the fuse midway stop machine carved, clepsydra, carving,



1. Control card failure.



2. The inverter.



3. The file path is wrong.



4. Electrostatic interference.



5. There is something wrong with the software Settings.



6. Drive failure or current segmentation set wrong.



7. Cable fault.



8. Computer has a virus, or system problems.



3, boot no action



1. Check the power supply system or mains fuse



2. Write the correct parameter



3. The mainboard or drive failure



4, machine and sometimes there is light, sometimes there are no light



1. Clean or replace the lens, adjusting light path



2. Clean or replace the water pump, dredge pipe



3. Replace the water conservation



4. Alternate to replace the above accessories, find reason



in order to reduce the CO2 laser engraving machine fault, machine maintenance is essential, especially now that summer. Specific maintenance measures can refer to: summer CO2 laser engraving cutting machine maintenance measures above is small for CO2 laser engraving machine breakdown maintenance, if any problem, please consult customer service laser equipment factory. Besides laser equipment factory provide model cutting machine, laser engraving machine, laser equipment.