Buy computer engraving machine needs attention

The size, wide choice customers should be based on business needs and financial conditions, the choice suits own engraving machine type and the size of power. Generally small engraving machine below 600 mm * 600 mm and 600 mm * 900 mm, and feed width is 700 mm. Carved double color plate is the most basic application of small wide engraving machine, a wide acceptance. Again a little bit small engraving machine with similar price, but to cutting board, double color boards carving more troublesome and unnecessary waste. Large-format engraving machine with 1200 mm * 1200 mm, 200 mm * 1500 mm, 1500 mm * 2400 mm, 2400 mm * 3000 mm, the carving machine feeding width of the above models are more than 1350 mm, now on the market of organic glass and the size of the PVC board is 1300 mm * 2400 mm, so these a few model on the demand side carving machine is suitable for the customer. Second, small wide machine precision carving characters 1 mm, 1 or large format engraving machine. 5 mm small, under a magnifying glass to see very clear. 3. The choice of control mode and speed: now control mode can be divided into three types: A, all the operation should be completed with computer control, carving machine computer at work in the working state, can't be other layout work, this might solid computer waste caused by the wrong operation. B, using single-chip microcomputer control, the controller can undertake typesetting in engraving machine working at the same time, but can't shut down computer, this is actually equivalent to a savings and a computer, and to reduce the waste caused by the wrong operation of the computer. C, using USB port to transmit data, the system has more than 32 m memory capacity. Just save the file, you can immediately without the computer, shut down the computer or other layout. This approach greatly improved the engraving machine work efficiency. Four, guide the import of large format engraving machine must broaden of square guide rail, the load capacity and the ability to maintain accuracy is more than 30 times that of circular guide rail, to ensure the high quality high speed engraving machine. Five, the spindle motor spindle motor is an important parts of computer engraving machine, the performance of computer engraving machine has vital effects on the performance of the machine. Machining spindle is usually divided into two categories: precision machining spindle and high power to cut off the spindle. 1, fine machining spindle is characterized by low noise, high speed, height, suitable for machining special fine artifacts, such as seals, nameplates, badges gifts, etc. Such motor is usually high speed frequency conversion motor, power is small, under 250 w. Weakness is the ability to cut off the thick material is bad, not to cut off the thicker material. 2, high power to cut off the spindle, is mainly used for cutting, high power, is characterized by large power, strong cutting ability, especially suitable for cutting yu, three stereoscopic word, of course also can make the breastpiece, nameplate, seals, etc.