To improve the service life of the stone engraving machine, woodworking engraving machine several skills

how to improve the service life of the stone engraving machine, woodworking engraving machine? Jinan shu can give you some Suggestions for reference below

in order to improve the service life of the stone engraving machine, woodworking engraving machine, often maintenance is the key.

a, stone engraving machine, woodworking engraving machine cleaning

, a finished work should be clear in time, provide convenience for the next work.
chip, clear guide rail and guide on the side of the material, in order to prevent the machine caused by debris interference, a lag in the process of work.
, regular cleaning screw, prevent with foreign body on the screw, screw in the equipment is very important, it determines the precision of the machine.
, regular cleaning engineering control box, dust is circuit board's Max killer.

2, stone engraving machine, woodworking engraving machine oil

guide rail and ball screw, the first is clean, not depilate cloth are available on the guide rail and ball screw grease and material scrap. Because the temperature is low, can add oil all the guide rail and ball screw, put in antifreeze oil well.
, refueling cycle for twice a month, or every two weeks to add oil at a time. If not for a long time,
and machinery to be lubricated periodically empty, to ensure the flexibility of the transmission system.
, after a slow walk, ensure uniform lubricating oil to add to the guide rail and ball screw.

3, stone engraving machine, woodworking engraving machine working environment temperature
, guarantee the preparation temperature, good at room temperature.
and check the oil standard applicable temperature, less to achieve Minimum temperature.
, machine need not when, if good room temperature low pour out the water in the tank, to prevent the frost crack water tank and the water pipe.

4, woodworking carving machine cooling water use

, cooling water is the important condition of the normal work of the spindle motor, if the water too dirty can cause serious damage to the motor, so should be to ensure that the cooling water clean, ensure the normal work of the pump.
and pay attention to the water level, must not water shortage phenomenon in a water-cooled spindle motor, the motor heat cannot be derived in a timely manner.
, attention to the environment temperature, be careful the water tank and conduit frost crack caused by the water temperature is too cold.
, conditional can use antifreeze liquid cooling.

5, stone engraving machine, woodworking engraving machine computer maintenance

dust, regular cleaning case, pay attention to the case of cooling, dust caused by too much card error control in the carefully.
, regular disk fragmentation, optimization of computer system,
, regular killing virus, but must pay attention to the work, can not open the antivirus program to prevent interference with work.

adhere to in accordance with the above points, I believe you of engraving machine should be able to use time longer, and can keep good state in use, prolong service life.