Enclosed Type

The parameters of laser cutting machine

by：Transon 2020-11-01

Laser cutting machine is the reference point switch to coordinates relative to the mechanical origin, modify the address of reference point is to change the origin position. Pr. 48 r。 48 Pr. 49个r。 49 Pr. 50个r。 Back to the reference point (50 ×0. 1毫米/分钟) Crawling speed ( ×0. 1毫米/分钟) Way back and try again, back to action immediately. Automatic punching machine back and try again. Machine in position between the limit switch can launch, back straight to the reference point switch. ( Note: Pr. N parameters for positioning module serial number) Machine back when, in case of the reference point switch before the positioning of the speed. Machine back when, after meet reference point switch positioning speed, this parameter is not set. Zero: don't perform the function of back and try again. Laser cutting machine if positioning speed value is less than the speed limit, the actual plus, deceleration soft limit before and after the limit ( ×0. 1um) , laser cutting machine speed limiter and the speed limiter to slow down, the time required to 0.

Custom message