Nantong - laser cutting machine And the characteristic of 63 t / 2500 cutting machine

Cutting machine at the bottom of the upper die downward when necessary to ensure there is a thickness of the gap. Such as bending sheet of 4 mm, need to choose around 32 slot. Stroke is the regulation of electric adjustment and manual fine tuning. Laser parts monthly clean laser parts ( Base board, valve, motor, pump, tubing, etc. ) , prevent dirt from entering the system, cannot use cleaner; Phone use after a month, check whether there is any deformation on the oil pipe bend, bending machine must be changed if there is abnormal, use two months later, should tighten the joint of all parts, for the work should be shut down, when the system pressure. Bending notch is choice, generally choose thickness of 8 times the width of the slot. Every time, filter oil change, filter should be replaced or cleaned thoroughly. Associated with the machine alarm or clean oil filter and other abnormal, should be replaced; Tank on the air filter, clean every three months to check, good 1 year replacement. The maintenance content is as follows: laser oil weekly check the tank oil level, such as laser system should also check after repair, oil level is lower than the oil window should include laser oil; This machine is used for laser for ISO HM46 or MOBIL oil DTE25; New work 2000 hours after the oil should be replaced, later every work of 4000 ~ 6000 hours after the oil should be replaced, the oil change every time, should be cleaning tank; System oil temperature should be between 35 ℃ ~ 60 ℃, shall not exceed 70 ℃, such as too high will lead to damage of metamorphic oil and accessories. Stroke adjustment, cutting machine use must pay attention to adjust stroke, before bending test. Adjust behind usually have electric adjustment and manual fine tuning, method with cutting machine. Otherwise, can cause damage to the mold and machine.
nantong - laser cutting machine 63 t / 2500 cutting machine structure using method is connected to the power supply first, open the key switch on the control panel, then start pump. Stepped on the foot switch to bending, cutting machine and cutting machine is different, can loosen, loosen the foot cutting machine was stopped, to inherit the downward. Maintenance and preventive maintenance on machines, laser cutting machine or brush machine, bending machine should aim the upper die down after the lower die shut down, until the work is completed, if you need to boot, or any other manipulation, should will choose in manual mode, and to ensure safety.
。







laser cutting machine laser oil should begin from the following options