Jade carving machine common problem solving methods

Jade carving machine appeared in the process of using one of three axis shaft can't move, three axis are not active, the spindle will not operate properly, these problems should be how to deal with? Next, the sculpture - factory house CNC, summarizes the jade carving machine for everybody common problem solving methods: 1, one of three axis shaft can't move at this time to check the corresponding shaft of the drive block is damaged. Inspection method can be used to replace method: the fixed axis of the aviation plug, plug corresponds to the shaft of the other active drive block. If after exchange fixed axis normal running, can show that the shaft of the drive has been damaged, need to replace a good driver block. If still won't do that cable fixed axis or replace defective cable or motor. Two, three axis are not active at this time to check the shaft have aviation plug and control box, power control box is opened. Whether the data line and control box and control card connected to the PC host. If all above, please contact the manufacturer. ( 3) First check the jade carving machine spindle will not operate properly inverter LED display shows the error code ( See the inverter specification error code) Contact the manufacturer. YIXING series inverter common faults and processing ( 1. 5 kw) Fault code: dL output short circuit check whether the motor and cable is short circuit OL1 OL2 too much load motor blocked out locked-rotor phenomenon
reduce load LU owe voltage input voltage abnormal check input power OH heat load is too big load
to replace the fan cooling fan any ( Note: when the inverter show DL reset button is invalid, please restart the power inverter, troubleshooting) TALENT series inverter common faults and processing ( 2. 2 kw) Fault code: EOCd output short-circuit short-circuit EOU
check motor and cable input voltage check EOCn too high voltage output circuit and short circuit or to ground short circuit check the wiring and electrical ELU if there is a large starting current in the same power system load
rewiring avoid load TL external force control line is separated from high voltage linear spindle motor common faults and processing: ( 1) Motor burning: check work of circulating water pump is normal, 2) Motor boring: check whether the motor line lack of phase, whether cable short circuit ( 3) Motor abnormal voice: motor over load operation of whether internal fault, Please contact the manufacturer) ( 4) Motor reversal: check whether the motor line lacks will output the UVW end any exchange at both ends