Enclosed Type

How to correctly install the CO2 laser tube?

by:Transon     2021-01-08
Because there are often said: customer response & other; Don't know how to properly install the laser tube? ” 。 In order to help customers after the purchase of equipment, solve the problem of pipe installation and replacement, laser sister today about the share of CO2 laser tube installation method to you.
first of all, let us know laser equipment factory group, CO2 laser tube in China. Customers will find the same power laser tube has a catalytic type and seal type two kinds. So, what is the difference between the two?


1, the principle of difference type catalytic co2 glass laser tube ( Enhanced) Is a traditional sealing from an upgraded version of laser tube, by plating nanometer high efficient catalyst in the laser discharge tube thin film, raise service life and power and through the adjustable inner cavity structure ( Double flanged) , fixed in the production of thermal stress and expansion coefficient difference between materials cause the loss of the inner cavity of precision, greatly improving the quality of the laser tube out light, cutting efficiency and sculpture in the application of precision is improved.

2, the difference between physical
catalytic and seal from the laser tube differ in that the tail end of the pipe and the catalytic laser tube tail is one type of metal, away from the laser tube tail is one type of glass.


3, the performance difference between life: catalytic pipe average service life than the seal from rose more than 15%
flare: catalytic laser tube light is more exquisite, spot diameter smaller than seal from 1. About 5 mm
power: catalytic tube measured peak power is higher than from the tube sealing around 10%

so, how do laser tube installed correctly? The following four steps to teach you a simple fix!


the first step of CO2 laser tube installed on the back of the machine, open the laser protection cover, can see two laser tube support and open cover to protect sensor, open protection for equipment matching parts ( The double laser machines have four) 。 
先打开两个支座,将激光管出光口( Negative extreme) Carefully in the direction of the number one reflector on the v-shaped support, as shown in the above.


in step 2 and then the laser tube bearings and screw down the screws on the belt buckle, the laser tube fixed well, note: don't twist the fixed laser tube too tight, so as not to damage the laser tube. Be sure to keep the inlet pipe ( The light end) Located in the tube body below. Three step



fixed after laser tube, will connect the water inlet pipe at the end of the protection and the laser tube negative extreme inlet connected to the other outlet pipe with the laser tube high pressure outlet connection is good, as shown in the above. Note: the water connection to docking and firm, to prevent leakage. Hose to rationalize cannot be discounted, lest cause water not free. Four

steps in the end, through the laser tube power supply cord casing thread hole to the laser power, laser tube is connected to negative connection and laser power supply is negative, the laser power is negative also are required.

more than watching the laser tube installation, you learned? Haven't remember little buddy can pass this & other; Dry goods & throughout; Collection, for a rainy day! In addition, dear customer if other problems in the process of using the equipment, can be directly dial service special line 0769 - China laser equipment factory 89839999 turn line 1 get more solution; If need to buy a new laser tube, but in our official taobao & other; China laser equipment factory energy mall & throughout; Self-help order, more discount waiting for you!




China professional manufacturer of laser equipment, laser laser equipment factory group products are laser cutting machine, laser marking machine, laser cutting machine, such as dalian, welcome to come to consult.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...
88888888888888888888888