The failure analysis of engraving machine operation often solve

The failure analysis of engraving machine operation often solve a lot of customer calls to ask some engraving machine in use of often appear problem, we compiled a technical information about carving machine maintenance, in order to offer the reference customers maintenance: a: carving machine shaft or triaxial abnormal 1: don't go for a walk or move around loose control card or malfunction. 2: the corresponding shaft drive failure. 3: the corresponding axis stepper motor fault. 4: the corresponding shafts, broken or loose. 5: the corresponding fracture or screw nut screw failure. 6: the corresponding axial sliding fast fault occurs. 7: drive set in the fine fraction, current, and software. 2: carving machine z axis is out of control 1: loose control card or malfunction. 2: electrostatic interference. Line 3: the z axis motor fault 4: file path is wrong 5: inverter interference 6: there is something wrong with the computer system or a virus 7: third error: error 1: loose control card or fault 2: drive failure 3: stepper motor fault 4: static 5: motor fault 6: cable fault 7:8: wrong path connecting shaft is broken or loose 9: processing speed fast zero: computer system problem or virus 4: carving two-tone 1: loose control card or fault 2: step motor near fault 3: drive failure or current segment with the software set up 4; Z axis motor fault 5:6: spindle motor fault inverter interference or wrong data set 7: static 8: a computer virus or system problem five: 1: carving control card fault 2:3: frequency converter interference file path is wrong. 4:5: static software set question 6: drive failure or current segmentation set wrong 7: cable fault 8: computer system with a virus or question 6: engraving machine wash bottom uneven 1: no vertical spindle and mesa. Need correction 2: knife with question 3: there is something wrong with the control card 7: mechanical engraving machine can't normal back the origin 1:2 in the opposite direction: loose control card fault or 3: limit switch or cable fault 4:5: drive failure step near motor fault 8: engraving machine engraving line wider? Solution: 1, 2, adjust the focal length of the focusing tube correctly adjusting the current solution: 1, 2, adjust the focal length of the focusing tube correctly adjust current 9: carving machine computer signals cannot be caused by the reasons: 1, 2, machine software parameter setting is not correct and not computer online 3, 4, software, there is something wrong with the computer serial port transmission rates do not agree with engraving machine baud rate set solutions: 1, reset the parameter 2, press the 'offline', make the offline lights went out