Enclosed Type

The analysis of the causes of laser cutting machine hook edge is not closed

by：Transon 2020-10-27

Hook side not closure is one of the common fault of laser cutting machine, it has the following six reasons: first, the measurement of laser cutting machine beams are parallel, under normal circumstances, left and right deviation should be no larger than 2 mm, adjust the beam eccentric wheel to change the parallel beams, as to achieve the required range of error. Second, check whether the laser cutting machine car belt and belt elastic beams is appropriate, is the same on both sides of the belt tensioning degree, adjust the belt tension, two side do not differ too much. Third, first disconnect the car and motor line beam, push and pull the car and beam is smooth. Fourth, check the beam bearing wheel on both sides of the laser cutting machine if there is any damage or resistance, bearing wheel is damaged. Fifth, laser cutting machine boot mode, push and pull vehicles and beams with the hand, gently move up and down the car head, look to whether have mechanical clearance, intensify the synchronous wheel shaft, the car gap is too big need to change the slider. Sixth, to see if there are any more mistakes, the original graphics such as graphics overlapping, not closed, lack of strokes, etc. , to correct errors in the graphics output again after test.

Custom message