Enclosed Type

Laser cutting machine water tank and the lens cleaning and maintenance matters needing attention

by：Transon 2020-11-01

How to cleaning and maintenance of laser cutting machine and lens one, the change of water and water tank cleaning 1, advice: clean water tank and replace circulating water every week 2, note: the machine work before must ensure that the laser tube is full of circulating water. Circulating water quality and water temperature directly affects the service life of laser tube, it is recommended to use pure water, and to control the water temperature below 35 ℃. For more than 35 ℃ to replace the circulating water, or to add ice to reduce the water temperature, water, Advice the user to select the cooling machine, or use two tank) 。 Clean water tank: first, turn the power off and remove water inlet pipe, let the laser tube of water into the tank automatically, open the water tank, pump and clear the dirt on the water pump. Good clean water tank clean, replace the circulating water, the water pump to restore back into the water tank, the connection pipe inserted into the inlet of the pump, tidy up the joint. 2 - the pump power alone, and running 3 minutes ( The laser tube is full of circulating water) 。 Second, the lens clean 1, suggest to clean before the work every day, equipment must be in a state of shutdown (1) the lens should be wiped gently, do not damage the surface coating; (2) to should take put down gently wipe process, prevent fall; (3) focus lens installation please be sure to keep the concave downward.

Custom message