Laser cutting machine safety technical requirements

Shear sheet for surface smooth, no shear unable to compress a narrow sheet. Bending machine pedal or button operation is commonly used in single or continuous cutting metal. Placed fencing, prevent the operator's hand into the scissors sets in the area. Manipulation of the cutting machine should pay attention to: when the various parts of the work should be seriously check before cutting machine is normal, electrical equipment are in good condition, the lubrication system was clear; Removal of mesa and its neighborhood place there are tools, measuring tool and other debris and marginal waste. Commonly used cutting machine can be divided into flat cutting, slitting and cut three types of shock. Cutting machine belt, flywheel, gear and shaft moving parts necessary to install shield. It should be adjusted according to delimit the cutting plate thickness, cutting machine of the scissors gap. Shearing machine is use more. It is forbidden to pick up waste on the ground at work, to avoid the fallen artifacts wounded. Don't alone control cutting machine, should by 2 - Three people coordination of material, dimension precision control and take the material, etc. , and determine the same command by 1 person. No shear at the same time two kinds of different specifications, different materials, sheet metal; Shall not fold material shear. Cutting machine of the flywheel, gear, shaft, tape and sports departments should be set shield. Cutting machine manipulator feeding mouth fingers away from the scissors should be kept at least 200 mm intervals, and leave the clamping device. Cutting machine is more widely used in machining a shearing equipment, it can cut all kinds of thickness of the steel plate materials. Settle on shear the trigger protective barrier can't block manipulator and eyes can't see the cutting parts. Homework after waste angular, operator should keep clear of in time, prevent stabbed, incision. Less than 10 mm thickness shear cutting machine for mechanical transmission, bending machine is more than 10 mm for laser transmission. Can't shear hardening far material, never promised to cut more than shear work ability.









pneumatic cutter shall abide by the law