Portable 5 in1 1500W 2000W 3000W Handheld Laser Welding Machine Stainless Steel Carbon Steel Aluminum battery welding
Enclosed Type
Laser cutting machine processing size in the cause of the error
by：Transon
2020-10-27
Laser cutting machine in the production work sometimes appear some problems, such as processing size is error.
This is one of the serious problem, if appear this kind of circumstance is has a great influence for the production efficiency, but also will increase the cost of production of enterprises.
What is the cause of the machining dimension errors that?
general situation down, said the cause of fault processing size error mainly has the following several aspects:
1, the signal is not normal. At this point the line needs to be replaced.
2, equipment, and computer bad earth. Right now you need to equipment and computer good grounding.
3, computer doesn't run well. This needs to be repaired or replaced computer computer.
4, computer operating system fault or infected with the virus. Need to reinstall the operating system or killing the virus.
5, the application software is not normal. Then you need to install the software and the motion control card driver software.
6, the instability of power supply or by the jamming signal. The need to add stabilizer or eliminate interference signal.
7, processing program to write is not correct. At this point need to check and repair process.
8, processing parameter setting is not correct. To set the correct processing parameters.
general situation down, said the cause of fault processing size error mainly has the following several aspects:
1, the signal is not normal. At this point the line needs to be replaced.
2, equipment, and computer bad earth. Right now you need to equipment and computer good grounding.
3, computer doesn't run well. This needs to be repaired or replaced computer computer.
4, computer operating system fault or infected with the virus. Need to reinstall the operating system or killing the virus.
5, the application software is not normal. Then you need to install the software and the motion control card driver software.
6, the instability of power supply or by the jamming signal. The need to add stabilizer or eliminate interference signal.
7, processing program to write is not correct. At this point need to check and repair process.
8, processing parameter setting is not correct. To set the correct processing parameters.
Custom message
Related Products
