Solutions for toolbar missing in MM3D software for 3D dynamic laser marking machines
Enclosed Type
Laser cutting machine hook closure problem of solution
by：Transon
2020-11-01
Laser cutting machine hook edge is not closed solutions
a, measuring beam is parallel laser cutting machine, under normal circumstances, left and right deviation should be no larger than 2 mm, adjust the beam eccentric wheel to change the parallel beams, as to achieve the required range of error.
2, check whether the laser cutting machine car belt and belt elastic beams is appropriate, is the same on both sides of the belt tensioning degree, adjust the belt tension, two side do not differ too much.
3, first disconnect the car motor line and beams, push and pull the car and beam is smooth.
4, check the laser cutting machine on both sides of the cross beam support wheel if there is any damage or resistance, bearing wheel is damaged.
on five, laser cutting machine, push and pull vehicles and beams with the hand, gently move up and down the car head, look to whether have mechanical clearance, intensify the synchronous wheel shaft, the car gap is too big need to change the slider.
6, check the original graphics whether there are any errors, such as graphics overlapping, not closed, lack of strokes, etc. , to correct errors in the graphics output again after test.
a, measuring beam is parallel laser cutting machine, under normal circumstances, left and right deviation should be no larger than 2 mm, adjust the beam eccentric wheel to change the parallel beams, as to achieve the required range of error.
2, check whether the laser cutting machine car belt and belt elastic beams is appropriate, is the same on both sides of the belt tensioning degree, adjust the belt tension, two side do not differ too much.
3, first disconnect the car motor line and beams, push and pull the car and beam is smooth.
4, check the laser cutting machine on both sides of the cross beam support wheel if there is any damage or resistance, bearing wheel is damaged.
on five, laser cutting machine, push and pull vehicles and beams with the hand, gently move up and down the car head, look to whether have mechanical clearance, intensify the synchronous wheel shaft, the car gap is too big need to change the slider.
6, check the original graphics whether there are any errors, such as graphics overlapping, not closed, lack of strokes, etc. , to correct errors in the graphics output again after test.
Custom message
Related Products
