Laser cutting machine fault emergency solutions

As these reasons can be the oil tank to liquid mouth more than 5 mm above the liquid hole completely flooded; Check whether fast-forward speed too fast, cause the lack of liquid. Need to clean the laser class cutter mold filling valve to install the valve core. Such as laser cutting machine through the modification of afore-mentioned reasons can mould system parameters reduce the speed of fast forward; Check whether the laser class cutter mold filling liquid valve is fully open, if is due to the oil pollution, bending machine to make liquid valve valve core flow is not flexible have card lag phenomenon caused by insufficient liquid.

。

proportion of laser cutter mold overflow valve solenoid coil is class, proportional solenoid coil voltage is in accordance with the requirements, if be this reason, please check the related electrical reason; Check whether the cartridge valve is stuck or the main valve core are jammed, and damping holes blocked, if be this reason, please remove the laser class cutter mold overflow valve is clean, put on again; Three-phase power supply phase modulation, causing the motor reverse; Check whether the laser class cutter mold tank oil level is too low, liquid mouth not flooded in, and fast forward when liquid on the oil cylinder cavity suction empty cause lack of liquid.
mould is to use laser cutting machine processing sheet metal forming tools, in the process of the development of the mould has been play an important role, but we also cannot deny, laser cutting machine mould will also be some questions on the block mould of fruit development. Bending machine we have here is for everyone to explain some laser cutting machine fault emergency solutions.










the strengths of the stainless steel laser cutting machine