The organs of stone carving in stone uneven solution!

Many stone carving machine users in actual carving will certainly encounter such a problem: how do I carved tomb some places just to carving, and in some places is darker than the depth of the set? It involves the widespread tombstone find level problem. Before leaving the factory of stone carving machine platform with milling cutter leveling, so there is no mesa rugged phenomenon; But we used for carving headstone or SLATE is certainly have error, could not have exactly the same as the up and down or so is flat and level. When we are in the lower left corner of the material of cutter, may be this is the highest point of the material, the actual carving, the places where low might just carved to, may be more shallow to no effect. If this is the low of the materials, the actual carving, the higher places could be carved is deep. So how to avoid such situation, which requires the skills and experience. One way is to machine to the origin, separate the x, y axis and z axis to x, y axis is located in the lower left corner of the material, the z axis is moving to the middle parts of the material to the knife, so the depth of the carved out will be a little more evenly. If materials differ too much, need to be carved path is divided into 3 or fluctuation two parts to keep separate the three parts, the knife or y in the lower left corner, when word of the z axis is the time to carve each part to the middle of the part of the corresponding to this engraving effect will be better. Another way is to use machine to measure the four angles of material, according to the x axis have a look at which position is high, which position is low, and then under the material of appropriate cushion something, try to keep the material level. As well as a method that USES the other measurement tools to assist engraving machine carved. Tend to be measured with lettering treasure this tool to add software to operate. General is before the first carved stone with measured data in the engraving machine imported into the path in the recount, finally in sculpture, this technology is not particularly adult do not recommend you use! Again try to choose flat stone material for sculpture so convenient and quick also is beautiful!