Enclosed Type

Reset is not straight metal laser cutting machine breakdown maintenance

by：Transon 2020-11-01

Metal laser cutting machine is now processing for advanced equipment, the processing, occasionally encountered metal laser cutting machine fault reset is not normal. Encountered such a situation, what should we do? Shenzhen di below can laser analysis solutions for you. Metal laser cutting machine reset abnormal reasons including the several aspects; 1, metal laser cutting machine X axis and Y axis movement in the opposite direction, and the impact side, this phenomenon is to check whether the mainboard parameters error, should stop check motherboard parameter is set to see if there is a problem. 2, metal laser cutting machine control panel display is normal, the X axis and Y axis to be not moved, can try to put the motherboard sensor terminals pulled out, and see whether the machine have action, this situation is about to consider replacement sensors. 3, beam reset is normal, laser cutting machine X reset motionless, may motor line break or motor shaft is broken, this kind of phenomenon to replace the motor line or small. 4, when the reset in the right direction, but in the vertices, we cannot stop to X or Y axes ( Check the mainboard parameters) , if correct, this kind of phenomenon to check the mainboard or sensors, replace ruled out. Master some skills is very convenient, just remember these factors, the next time I encountered metal laser cutting machine reset is not normal, suit the remedy to the case, all problems will be easy.

Custom message