Notice of Spring Festival
Enclosed Type
Laser engraving machine carving picture steps
by：Transon
2021-01-08
Laser engraving machine engraving pictures steps:
1, put a small laser engraving machine carving object 15 cm.
2, and then the bluetooth pairing with smartphones. And choose to print pictures.
3, in a dedicated app files on the SD card on the selected output laser engraving.
4, then you can print out the pictures on the good choose goods.
note
1, when using the automatic focus, pay attention to the automatic focus measurement must be tightened, or work surface would be to the laser.
2, laser engraving machine at work, open the machine cover is prohibited.
3, processing when open the exhaust smoke, smoke blown equipment.
4, processing and wood, paper, so as to avoid fire must pay attention to the processing speed.
5, irregular processing when the initial users to red light positioning.
6, processing wood veneers, fluidity material, xiao yu 1 mm to adjust the amplitude of water.
7, cutting processing, to use artifacts from table 2 centimeters of above.
8, reflection lens and focus lens cleaning: two fingers hold the reflective lenses. On the other hand paper to clean the lens of your camera lens.
9, usually carved vector file, the resolution shall be adopted, carving point, when there is a low resolution should be chosen.
1, put a small laser engraving machine carving object 15 cm.
2, and then the bluetooth pairing with smartphones. And choose to print pictures.
3, in a dedicated app files on the SD card on the selected output laser engraving.
4, then you can print out the pictures on the good choose goods.
note
1, when using the automatic focus, pay attention to the automatic focus measurement must be tightened, or work surface would be to the laser.
2, laser engraving machine at work, open the machine cover is prohibited.
3, processing when open the exhaust smoke, smoke blown equipment.
4, processing and wood, paper, so as to avoid fire must pay attention to the processing speed.
5, irregular processing when the initial users to red light positioning.
6, processing wood veneers, fluidity material, xiao yu 1 mm to adjust the amplitude of water.
7, cutting processing, to use artifacts from table 2 centimeters of above.
8, reflection lens and focus lens cleaning: two fingers hold the reflective lenses. On the other hand paper to clean the lens of your camera lens.
9, usually carved vector file, the resolution shall be adopted, carving point, when there is a low resolution should be chosen.
Custom message
Related Products
