TS1610 Dual Heads CO2 Laser Cutter Machine Auto Feeding Fabric Laser Cutting Machine
Enclosed Type
Laser cutting machine the commissioning and operation of the machine
by：Transon
2020-10-29
The workpiece on the workbench middle pressure testing machine.
Sheet metal bending should be in the middle of the machine, should not be partial load and unilateral load, so as not to affect the workpiece and the cutting precision of the machine, such as some of the artifacts is really necessary unilateral work, its load should be less than 100 kn, but should be both sides folded plate in order to solve a unilateral partial load.
On the upper and lower mold center.
The length of the folded plate are not allowed to do full load when less than 600 mm (
1000).
The folded plate work (
Every 100 mm length of the folded plate load does not exceed 100 kn)
。
Define the space between the upper and lower mold, and to adjust.
Pay attention to the sealing condition of seal, seals found leaking transferred in good time.
commissioning must in all lubricating points before filling calcium base grease ( See the lubrication sign) 46 # laser, laser system inside the tank to join oil, for the first time in a month after the change, after a year, according to the details and change the oil, low oil temperature is not lower than 15 ℃. Test should pay attention to when the motor steering ( Counterclockwise) 。 Once again, adjust the die clearance, adjustment on mold piece when necessary. Norms movement 'point', 'single' or 'continuous', and by the switch to choose. Locate keep-off before and after. According to the thickness of the sheet metal and folded plate length calculation or consult the bending force and lower die shy of V groove size ( Die size should be greater than is commonly thickness of 8 times) 。
。 Trial run for the first time, start the oil pump electric thought group of idle running, and then to 'dot' cutting machine to test machine movement; Then test the 'single' and 'continuous' action and stroke, the control function, behind when confirmed the machine run normally, can follow the steps below.
no indentation cutting machine design of bending skills and strengths
commissioning must in all lubricating points before filling calcium base grease ( See the lubrication sign) 46 # laser, laser system inside the tank to join oil, for the first time in a month after the change, after a year, according to the details and change the oil, low oil temperature is not lower than 15 ℃. Test should pay attention to when the motor steering ( Counterclockwise) 。 Once again, adjust the die clearance, adjustment on mold piece when necessary. Norms movement 'point', 'single' or 'continuous', and by the switch to choose. Locate keep-off before and after. According to the thickness of the sheet metal and folded plate length calculation or consult the bending force and lower die shy of V groove size ( Die size should be greater than is commonly thickness of 8 times) 。
。 Trial run for the first time, start the oil pump electric thought group of idle running, and then to 'dot' cutting machine to test machine movement; Then test the 'single' and 'continuous' action and stroke, the control function, behind when confirmed the machine run normally, can follow the steps below.
no indentation cutting machine design of bending skills and strengths
Custom message
Related Products
