Flying Fiber Laser Marking Machine Automatic Mark Production Line For Can PVC Bags Plastic Bottle Marking Machine
Enclosed Type
Hollow metal laser cutting equipment pressure machine maintenance
by：Transon
2020-10-30
Say a major part of the laser cutting machine of the air compressor maintenance and how to carry out maintenance work: 1, the oil filter.
To replace a new one every 2000 hours.
2, oil drain valve. Every 2000 hours to discharge water and dirt.
3, the relief valve. Check whether the action sensitive every 4000 hours.
4, motor maintenance. According to the motor operating instructions for maintenance.
5, oil vapor separator. Need to replace a new one every 4000 hours.
6, small pressure valve. Once every 4000 hours cleaning, and check whether the open pressure is normal. 7, compressor lubricants. To check the oil every 1000 hours, enough to replace the new oil every 4000 hours.
8, drive belt. Every 2000 hours to adjust the firmness, abrasion of checking every 4000 hours, according to the wear condition to decide whether need to change. 9, the inlet valve seals. Want to be in laser cutting machine air compressor working 4000 hours, every check the seal condition, to be replaced when necessary. 10, air filter filter. In general every 500 hours to remove dust on the surface of the air filter filter material, check whether need to replace every 2000 hours. Inspection or replacement cycle according to extend or shorten the dustiness.
2, oil drain valve. Every 2000 hours to discharge water and dirt.
3, the relief valve. Check whether the action sensitive every 4000 hours.
4, motor maintenance. According to the motor operating instructions for maintenance.
5, oil vapor separator. Need to replace a new one every 4000 hours.
6, small pressure valve. Once every 4000 hours cleaning, and check whether the open pressure is normal. 7, compressor lubricants. To check the oil every 1000 hours, enough to replace the new oil every 4000 hours.
8, drive belt. Every 2000 hours to adjust the firmness, abrasion of checking every 4000 hours, according to the wear condition to decide whether need to change. 9, the inlet valve seals. Want to be in laser cutting machine air compressor working 4000 hours, every check the seal condition, to be replaced when necessary. 10, air filter filter. In general every 500 hours to remove dust on the surface of the air filter filter material, check whether need to replace every 2000 hours. Inspection or replacement cycle according to extend or shorten the dustiness.
Custom message
Related Products
