Determinants of laser cutting machine cutting effect

Effect of laser cutting machine for cutting the determinants of 1, the cooling system to ground, clean the water tank and water, refrigeration temperature control water tank temperature control point to justice, otherwise causing the deterioration of condensation power and laser tube is easy damaged, pipe head loss, shorten the service life of cold water, sometimes doesn't work, constantly in the tube. 2, water conservation should often check the cleaning, cooling water cannot be boiled water often float switch or water protect float switch is no longer a, sub solution will not be used. 3, laser cutting machine, laser tube installed protection to reasonable, protection should be in a quarter of the total length of laser tube place, cause otherwise laser speckle pattern becomes bad, some work for a period of time of light into a few points, causes the laser power drop can't meet the requirements, cause continuously in tube, 4, focus lens and mirrors, working for a moment frames are fever, lens surface discoloration rust; Take off the film cracking are to replace the object, especially a lot of customers with large air pump and air compressor, so the water very quickly on the focus lens, so must check the lens optical path system clean on time and quality. 5, suction device should be timely check the clear, clean up the fan duct. Otherwise, a lot of smoke dust not to go out, serious pollution of the lens and the laser tube quickly and make each machinery and electronics components easily cause bad contact oxidation. 6, electricity power grid power to match. 7, laser cutting machine can't be too bad work environment, if the environment temperature is higher than 30 degrees, below 18 degrees, dust is too much, air pollution is serious, so serious damage to the machine, failure rate is rising; All electrical accessories under the moist environment problem very easily. 8, the laser tubes work current to justice, not 90 - for a long time 100 the intensity of work; To the reasonable application of the laser and the laser energy saving; Light path system is clean and accurate, otherwise the laser tube, premature aging and fracture so strong laser machine work time should be adjusted in the 50 - 60%, and then adjust speed according to the material.