Pay attention to air compressor maintenance in laser cutting machine, etc

Pay attention to air compressor maintenance in laser cutting machine, etc. Laser cutting machine adopts air cutting, the air compressor is a very important auxiliary equipment, while the air is no cost cutting, but for the air compressor maintenance or have to pay attention to, because it directly affects the air purity and pressure, on the whole have affect the cutting quality. Share below we will give you the air compressor maintenance steps: 1, check the air filter filter. In general every 500 hours to remove dust on the surface of the air filter filter material, check whether need to replace every 2000 hours. Inspection or replacement cycle according to extend or shorten the dustiness. 2, check the inlet valve seal. Want to be in laser cutting machine air compressor working 4000 hours, every check the seal condition, to be replaced when necessary. 3, check the compressor lubricants. To check the oil every 1000 hours, enough to replace the new oil every 4000 hours. 4, should check the oil filter. To replace a new one every 2000 hours. 5, should check the oil vapor separator. Need to replace a new one every 4000 hours. 6, check the small pressure valve. Once every 4000 hours cleaning, and check whether the open pressure is normal. 7, should check valve. Check whether the action sensitive every 4000 hours. 8, should check the oil drain valve. Every 2000 hours to discharge water and dirt. 9, should check the drive belt. Every 2000 hours to adjust the firmness, abrasion of checking every 4000 hours, according to the wear condition to decide whether need to change. 10, motor maintenance should be paid attention to. According to the motor operating instructions for maintenance. In order to make the air compressor of laser cutting machine can run normally and reliably, ensure the service life of the unit, must develop detailed maintenance plan, implement during operation, regular maintenance, regular inspection and maintenance, keeping air compressor unit, clean, no oil, no dirt.