JPT Pulse Air Cooling Laser Cleaning Machine 100w/200w/300w/500w Fiber Laser for Steel Surface Rust Removal for Steel Rust
Enclosed Type
Laser cutting machine water-cooled machine matters needing attention
by：Transon
2020-10-27
Laser cutting machine work under the high temperature environment need to be safe at all times, especially cold water machine.
Because water cooling machine is the core of the control of temperature of the laser cutting machine, if not taken, it is easy to cause high temperature, burning laser.
So, here small make up remind everyone what matters need to pay attention to water-cooled machine.
1, compressor overload warning light alarm.
Bad heat can cause condensation temperature and corresponding condensing pressure condenser is too high, so that the pressure controller and pressure, compressor overload protection, due to the compressor stop the opportunity to influence customer's normal use.
Cold water machine should be placed in ventilation, heat dissipation good position.
2, abnormal pressure gauge.
Cold water machine in normal operation, the high pressure should not be greater than 2.
0 mpa, if more than the pressure of the condenser cooling, the solution is the high pressure gas cleaning the dust on the condenser heat sink, no pressure gauge equipment regularly clean the condenser heat sink;
Low pressure should not be less than zero.
2 mpa, if under the pressure of the condenser have leak phenomenon of fluorine or throttling dirty blocking phenomenon.
3, refrigeration effect.
Long not to clean water tank, water tank inside the evaporator heat transfer caused by microbes and bad, affect the cooling effect.
Please change water general customers regularly cleaning tank and frequently in January to replace a pure water, and at the same time clean water tank,
Use detergent to clean)
To ensure that the cold water machine water clean.
Custom message
Related Products
