Enclosed Type

Laser cutting machine of the lens cleaning matters needing attention

by：Transon 2020-10-27

Laser cutting machine of the lens clean constantly, or it will affect the effect of cutting, in the process of cleaning, the first step I use blow the balloon's blow off of the surface of the original, especially the surface of small particles of flocculant and lenses, this step is necessary. But don't use the compressed air on the production line, because these would contain oil mist and water droplets in the air, it will deepen the pollution of the lens. The second step application analysis of pure acetone to a slight cleaning lenses. This level of acetone is almost no water, it will reduce the possibility of a lens pollution. Cotton ball dipped in acetone must clean under light lens, and make a circular movement. Cotton swabs with a dirty but, must be replaced. Wash one time to avoid to produce wave. If there are two coating on the surface of the lens, such as lens, in this way, every face needs cleaning. First need to put a layer of clean with protective lens paper. If acetone cannot remove all the dirt, then use vinegar to clean. Vinegar when cleaning is the use of dissolution of dirt to remove dirt, but won't harm the optical lens. This kind of vinegar can be experimental level ( Diluted to 50% intensity) , or family containing 6% acetic acid with white vinegar. Cleaning procedures and acetone cleaning, and then use acetone to remove vinegar and dry lens, are frequent in cotton ball to completely absorb acid and hydrate. Until clean. When through washing to remove pollutants and lens injury, especially caused by metal splash and dirt film burn out, to restore the good performance, the only way is to replace the lens.

Custom message