Factory 4 Function In 1 Raycus 3000w Metal Carbon Steel Aluminum Laser Welding Cleaning Cutting Machine With Good Price
Enclosed Type
Laser cutting machine light path adjustment method
by：Transon
2020-11-01
The method of laser cutting machine light path adjustment:
1, check whether the laser can play on the first reflection lens. （ The first mirror method is to use a plastic cover, press the TEST out the light to see the laser dot location) If the laser can't play in the first lens on the adjustment of the first lens position.
2, check the laser can play in the second and third reflective lenses, if not, adjust its higher level after the mirror M1, M2, and M3 screws.
3, in the laser tube into the mouth, light stick at least two layers of the double-sided adhesive, move the laser head to the top right-hand corner of the table according to the control panel of the TEST keys, a laser spot.
4, move the laser head to the upper left corner and then make a laser spot, observe whether the top right corner of the point in the same place, such as the second mirror is not in the same position adjustment of M1, M2, and M3 screws. Hit the point and the top right corner point in the same place.
5, move the laser head to the lower left corner, observe whether the dot and the top right corner in the same place, adjust the second reflection lens.
6, such as the above d, e repeatedly stated, the end of the laser spot three points in the same position.
7, check whether the focus is on the center: putting a mirror at the bottom of the focus lens in the vertical, under the lens barrel close to the party place (the tube, The handheld) Transparent plastic sheet press TEST type laser, the laser spot is playing in the center of the focusing lens. Hand is holding a plastic sheet should be carefully laser burns, do not put in the lens within the scope of the vertical plane.
1, check whether the laser can play on the first reflection lens. （ The first mirror method is to use a plastic cover, press the TEST out the light to see the laser dot location) If the laser can't play in the first lens on the adjustment of the first lens position.
2, check the laser can play in the second and third reflective lenses, if not, adjust its higher level after the mirror M1, M2, and M3 screws.
3, in the laser tube into the mouth, light stick at least two layers of the double-sided adhesive, move the laser head to the top right-hand corner of the table according to the control panel of the TEST keys, a laser spot.
4, move the laser head to the upper left corner and then make a laser spot, observe whether the top right corner of the point in the same place, such as the second mirror is not in the same position adjustment of M1, M2, and M3 screws. Hit the point and the top right corner point in the same place.
5, move the laser head to the lower left corner, observe whether the dot and the top right corner in the same place, adjust the second reflection lens.
6, such as the above d, e repeatedly stated, the end of the laser spot three points in the same position.
7, check whether the focus is on the center: putting a mirror at the bottom of the focus lens in the vertical, under the lens barrel close to the party place (the tube, The handheld) Transparent plastic sheet press TEST type laser, the laser spot is playing in the center of the focusing lens. Hand is holding a plastic sheet should be carefully laser burns, do not put in the lens within the scope of the vertical plane.
Custom message
Related Products
