medical mask

Daily maintenance of computer engraving machine

by:Transon     2020-04-23
Daily maintenance of computer engraving machine: a, continuous running time under 10 hours a day, ensure the normal work of the cooling water clean and the water pump, must not water shortage phenomenon in a spindle motor, regular replacement of cooling water, in order to prevent the water temperature is too high. If working environment temperature is too low in winter can replace the water inside cistern with antifreeze. Second, each machine after use, should pay attention to clean up, be sure to clean up the dust on the platform and the transmission system, on a regular basis ( A week) The drive system ( Three axis X, Y, Z) Lubricating oil. ( Note: X, Y, Z three axis polished rod with oil for maintenance; Add the butter screw rod part; If working environment temperature is too low in winter screw, polished rod ( Square guide or circular guide) First part should use gasoline to wash clean, then add oil, otherwise it will cause machine transmission part of the resistance is too large and cause dislocation. ) Three, to the electrical appliances maintenance checks is, must cut off power supply, to monitor display and main circuit power light goes out after may.
Custom message
Contact