Reason - when stone engraving machine carved dislocation - 【 】 Engraving machine _ _ _ _ CNC woodworking engraving machine engraving machine carving factory house

CNC machinery co. , LTD. , integrating research, development, manufacture various types of woodworking advertising engraving machine | jade stone carving machine | | metal mold engraving machine series of optical fiber laser five-axis robot | | styrofoam CNC mortise and tenon joint processing center production line | | customize household etc. Various kinds of CNC engraving machine series, just take a look at below small make up of stone carving machine when carving dislocation reason related information, hope to be of service, welcome to inquire!






stone carving machine often will appear the phenomenon of dislocation, a lot of people still don't know the cause of the stone carving machine so when maintenance should all don't know how to fix it. So, what is the cause of the dislocation in stone carving machine? Next, small make up on a simple analysis for everybody.






stone carving machine



1, the causes for the spindle motor: if the cause of the stepper motor or servo motor, the machine does not move in one direction, turn screw also turn to be not moved by hand.







2, the reason of the fuselage itself: a part of the machine tool has a problem, or loose, surface also can appear dislocation imagine such impurities, such as the coupling is loose, broken, dislocation will appear, guide rail, screw on time without cleaning refueling also can appear dislocation phenomenon.







3, engraving machine machine line if broken will appear this kind of phenomenon. Line is the control of the machine, in the case of not controlled naturally.







4, drive: the drive itself is a problem with the structure or electronic components can cause dislocation phenomenon, for this reason the most; If the number of occurrences of few, and put the rate low, sometimes can normal sculpture drives are still not completely broken, if the start engraving on dislocation drive has been completely broken, it can fix or worse drives.







5, the cause of the voltage, the power needed for the work, if the voltage is too low to drive power supply, power than can cause dislocation phenomenon, with the y axis, most commonly appear this kind of phenomenon may be the voltage is not enough, or someone on the same line using the large power equipment such as electric welding, etc. , this kind of good solution is to install a regulated power supply without W W, but the error range of regulated power supply best not more than five percent to three percent.







6, interface board, main board, the cause of the adapter plate: if interface board, main board, switch board is broken, the machine in working process, a certain direction or a three axis are not moving, causing dislocation carving.