Enclosed Type

Laser cutting machine parameter setting

by：Transon 2020-10-27

The first laser cutting machine parameter setting: laser parameters or set again, but adopts the intersection line filling method, also is the equivalent of a laser carving for 2 times. Reference parameters are as follows: a) : marking the frequency set to low frequency, it is recommended that the value is: 8000 - 20000. B: launch time is 1. 5我们。 C: filling way: cross line filling spacing: 0. 04 - 0. Between 6 mm. D: scanning speed: according to the situation, if the radium vulture border effect always have burrs phenomenon, can set speed value. Suggestion: - 500 1500. The second: adopt single wire filling, but set up the parameter twice. Launch time is 1. 5. Time: 1 slightly high frequency high power ( For example, 30000 - 70000). Speed slow down, For example, 700 - 1000). At that time, product surface after laser carving and residual paint, so you also need to set up the parameter 2 times. 2 times: slightly low frequency low power ( For example, 8000 - 20000). Real quick, For example, 1000 - 1600). 3. Product material for the ( Transparent plastic material) , the laser cutting machine to print in the middle ( White) Surface spray ( Black ink) , laser carving effect to the thief, the edge can't. Parameters are as follows: a: marking frequency to high frequency ( For example, 50000 - 100000). Page 1 b: launch time: a big dots, too. 35 us, for example, c: filling way: general for single wire filling, if not enough white, can use cross line filling.

Custom message