Enclosed Type

Laser cutting machine reset the analysis of the causes of malfunction

by：Transon 2020-10-31

Abnormal reasons from several aspects including the laser cutting machine reset; 1, laser cutting machine, the X axis and Y axis movement in the opposite direction, and the impact side, this phenomenon is to check whether the mainboard parameters error, should stop check motherboard parameter is set to see if there is a problem. 2, laser cutting machine control panel display is normal, the X axis and Y axis to be not moved, can try to put the motherboard sensor terminals pulled out, and see whether the machine have action, this situation is about to consider replacement sensors. 3, beam reset is normal, laser cutting machine X reset motionless, may motor line break or motor shaft is broken, this kind of phenomenon to replace the motor line or small. 4, when the reset in the right direction, but in the vertices, we cannot stop to X or Y axes ( Check the mainboard parameters) , if correct, this kind of phenomenon to check the mainboard or sensors, replace ruled out.

Custom message