Several effective rust removal methods for woodworking engraving machines

Woodworking engraving machine in the process of use may be affected by the working environment, prone to rust. At this time, it is recommended that you do not immediately discard the woodworking engraving machine or place it. You must take some measures to deal with the rust in time. So how to remove rust for woodworking engraving machine is the most effective? Woodworking engraving machine because of the working environment, if the maintenance is not timely, the spindle motor is easy to rust, slight rust does not affect the normal use of the spindle motor, but if it is not handled for a long time, it will shorten the service life of the spindle motor. Here are some simple derusting methods for everyone: 1. Clean lubricant can be used and sprayed evenly on the motor. Cotton cloth can be used to wipe off the rust on the stone engraving machine about half a child, if the rust is severe, spray more lubricant. Lubricating cleaner is not conductive and has good lubricating effect. 2, by manual knocking, shovel, scraping, brushing, sand or flexible method to eliminate the appearance of rust, oxide skin, etc. , this is the painter radical rust removal method. 3. You can also use tools such as Blade, scraper, pointed hammer, wire brush, emery cloth and broken saw blade. This method is relatively simple, but it is also easy to damage the machine. You should be very careful when removing rust, slightly don't pay attention to it will cause machine spindle off track. 4 often clean the wood cutting on the spindle, which can keep the cleanliness of the spindle. 5. Often oil the spindle and knife sleeve. 7. Water cooling spindle often replaces cooling water. The air-cooled spindle often decontamination the blades and oil the bearings. I don't know if you usually take the above methods to deal with the rust of the woodworking engraving machine, if not, you can try it.