Engraving machine how to maintain

A, preparation before starting the: 1. Power check and clean up the work surface. 1. 2 through to the power supply. 1. 3 watch carving machine is normal operation. 1. 4 work according to the actual situation, choose engraving machine belt, general Ф more than a quarter of dao is usually 5000 RPM to 6000 RPM. Ф0。 5 mm to 3 mm Ф knife is usually 8000 RPM to 10000 RPM. Second, the operating process: 2. 1 to the workpieces in the table on the left will be relative to the workpiece plastic mould put in on the right side of the table, on line correction and grips fastening of iron. 2. 2 according to the technological requirements for processing, hands holding the engraving machine arm, by needle by plastic mold processing slowly. 2. 3 complete checking machining parts whether meet the process requirements, and then loosen the horse iron artifacts. 3, note: 3. Don't wear the gloves while 1 operation, to avoid the burin and belt turn gloves and injured. 3. 2 should wear safety glasses when operating, to prevent iron shit fly in my eyes and love. Three, to turn it off: 4. 1 turn off the power supply. 4. Around 2 cleaning machine tools and health. 4. 3 filling grease in the sliding part. 5, maintain: 5. 1 check whether the switch of power supply, wires, and reliable. 5. 2 every day must check whether fixed screw machine parts and strong and reliable. 5. 3 often lubricating sliding parts listed on the machine. 5. 4 to check whether there is abnormal sound machine is working, if discovery is unusual situation should promptly notify the maintenance technician for repair, and maintenance record. 5. 5 every day after work when the machine must be cleaned and the surrounding environment health. 5. 6 every three months to conduct a comprehensive inspection and clean, and make corresponding records.