Cutting machine laser pump common faults and ruled out

The scattered laser components of cutting machine with tubing and pipe joint connection, form a complete laser system. The performance of the tubing, pipe joint structure on the working state of the laser system has a direct relationship. In the introduction of commonly used laser tubing and pipe, tubing and pipe joint always called cutting machine laser pump. ( 1) Cutting machine tubing in a laser cutting system, the use of tubing sort is more, there are steel pipe, copper pipe, nylon pipe, plastic pipe, rubber hose, etc. , should according to the discretion of the laser system pressure when selecting, laser components installation position, the laser equipment working environment and other factors. (1) steel tube divided into two categories, chu steel pipe and welded steel pipe. The former is generally used in high pressure system and the latter with low pressure system. The characteristics of the steel tube is: confined ability, low price, high strength, good rigidity, but more difficult assembly and bending. At present in all kinds of laser equipment, steel pipe application to a wide range. (2) the brass copper tube divided into two categories, brass tube and copper tube, multi-purpose copper tube. Copper board has the advantages of convenient, flexible assembly, but also has low strength, poor ability to resist vibration, the material price high, shortcomings and so on easy to make laser oil oxidation, commonly used in laser device internal pressure in the difficult assembly place or 0. 5 - 10 mpa in low pressure systems. Nylon tube (3) this is a kind of milky white, translucent new pipe material, bearing capacity is 2. 5 mpa and 8 mpa two kinds. Nylon tube with low cost and easy bending, but life is short. Use instead of brass using low boat system.









composite transmission and strengthening technique of pneumatic cutting machine