CNC engraving and milling machine using guide

CNC engraving and milling machine using guide: 1. Tool to use special detergent to remove dirt. 2. Jacket size to fit, cross section, not enough round, wear, inner hole taper collet must not choose, or it will cause the handle vibration, carved milling is the key to the ideal effect. 3. In body, clothes, hair and so on can't close to the objects in the work. 4. Tool to check its toughness, if using a blunt, please replaced immediately, if continue to use not only carved milling effect is not good, may also have a cutting knife. 5. The handle to clamp and moderate contact, insert the handle to be strong in the collet and tighten, if time is too long jacket used inner hole deformation, clamp must be replaced immediately. 6. When CNC engraving and milling machine is used to impose a, the thickness of the processing can't more than can the thickness of the cutting edge, responsible for still can appear broken sword. 7. Butter can prevent knives rust. 8. For different material cutting, should use reasonable cutting speed. 9. Recommend cutting speed to keep balance, speed consistent as far as possible, in order to achieve better results, cutting too long can't stay, the same to. 10. Cutting tool cannot be polished or change their form.