Woodworking engraving machine machine don't electricity to do when the phone is switched on - - Engraving machine _ _ _ _ CNC woodworking engraving machine engraving machine carving factory house

>
woodworking engraving machine machine no electricity causes more when the phone is switched on, but there are reasons for your reference





1, check whether the start button line is connected and the button is burn out;


2, check whether the ac contactor is short circuit or burn out;


3, check whether the abrupt stop switch is open;


4, check whether the fuse is burnt.





other engraving machine often appear failure





engraving machine machine no electricity on startup





1, check whether the start button line is connected and the button is burn out;


2, check whether the abrupt stop switch is in the pressed state.


3, the fuse is in good condition, and the internal line is empty.


4, button when motion axis in one direction only go





limit phenomenon appeared in the process of carving the





1, check whether the carving path is range of sculpture;


2, check whether the limit product is in good





engraving machine start reset when the beep or always good top limit switch bad





1, the plunger top limit switch, its calibration.


2, drive line contact is not good, try to fix the drive line it tightly.


3, limit switch line not connected, the line can be connected.


4, limit switch, switch of





often when hard material cutting knife carving





1, the carving is required for a hard material set different engraving parameters according to different materials, to use a different tool


2, select the appropriate lubricant