What kind of work does engraving machine needs to be done before and after use

Engraving machine operation is learned, simple to start the boot everyone, it is just move your fingers, but you certainly don't know at the moment you press the button of the whole machine working after what, let's not do a detailed understanding, for your machine maintenance and life is good. A regular killing virus, computer aspect, but pay attention to the work can not open the antivirus, be careful. Regular cleaning dust chassis, pay attention to the case of cooling, dust caused too much card error control in the carefully. Regularly organize disk fragments, optimization of computer system. Computer anomalies can also cause many problems, especially for the connection computer engraving machine, sharp and smart manufacturer is found in the process of maintaining woodworking engraving machine, computer exception to our maintenance also caused a lot of unnecessary trouble, also delayed the customer's business, sums up the intelligence technology, put forward the customer computer maintenance pay attention to several aspects. Second, clean up the regular cleaning engineering control box, dust, the biggest killer of circuit board. Regular cleaning screw, prevent with foreign body on the screw, screw in the equipment is very important, he decided that the precision of the machine, and screw also play an important role in the transmission process. Work is done to clean up the table timely, this will give woodworking engraving machine provides a convenient work next time. Clean up crumbs, guide rail and guide on the side of the material in order to prevent the machine caused by debris interference in the working process of the machine. Three, oiling after a slow walk, ensure uniform lubricating oil to add onto the guide rail and ball screw. Machine if not for a long time, should be lubricated periodically empty, to ensure the flexibility of the transmission system. First clean guide rail and ball screw, it can be a cloth do not put the chip on the guide rail and ball screw oil and materials. Because the temperature is low, can add oil all the guide rail and ball screw, best antifreeze oil. Refueling cycle to twice a month, that is, every two weeks to add oil at a time. Four, temperature machine need not when, if the room temperature low best poured out the water in the tank, to prevent the frost crack water tank and the water pipe. Ensure preparation temperature, woodworking carving machine at room temperature, best staff at least will not very cold. Check the oil standard applicable temperature, at least minimum temperature. The effects of temperature on woodworking engraving machine is not very big, but as a result of the user to screw with butter, winter also forget to clean up, each boot operation does not open, some workshop temperature is very low, although the oil, can still frozen, the machine running. Five, the cooling water can use conditional antifreeze liquid cooling. Pay attention to the environmental temperature, be careful the water tank and conduit frost crack caused by the water temperature is too cold. Cooling water is necessary for the normal work of the spindle motor, if the water too dirty can cause serious damage to the motor, guarantee the normal work of the cooling water clean and the water pump. Pay attention to the water level, must not water shortage phenomenon in a water-cooled spindle motor, the motor heat cannot be derived in a timely manner.