What are the necessary maintenance and maintenance for stone engraving machines?

Stone engraving machine is a precision numerical control equipment. Necessary daily maintenance is very important to the service life and precision of this machine. Please carry out maintenance and maintenance according to the following requirements. Maintenance: 1. Continuous operation time is less than 10 hours per day to ensure the cleanliness of cooling water and the normal operation of the water pump. Water shortage should never occur in the water spindle motor. Replace cooling water regularly, to prevent the water temperature from being too high. If the working environment temperature is too low in winter, the water in the water tank can be replaced with antifreeze. Second, every time the machine is used, attention should be paid to cleaning. The dust on the platform and transmission system must be cleaned up regularly (Weekly)To the transmission system (X, Y, Z triaxial)Lubricate and refuel. ( Note: X, Y and Z three-axis polished rods are maintained with engine oil; Screw part with high speed butter; In winter, if the working environment temperature is too low, screw rod and polished Rod (Square guide rail or circular guide rail) Some parts should be washed and cleaned with gasoline first, and then oil should be added, otherwise the resistance of the transmission part of the machine will be too large and the machine will be misplaced. ) Third, the maintenance inspection of the electrical appliance is to cut off the power supply until the monitor is not displayed and the main circuit power indicator is off. Maintenance: Modification of engraving machine parameters (Weihong system): Manufacturer parameter modification ,( Enter the password: NCSTUDIO Click OK ')Workbench stroke :(According to the model of the machine) System parameters: select the first four items based on the default. Motor Parameters: if the three axes are all screw drive machines, if the lead is 10, the motor parameters are 0. 00625, if the lead is 5, the motor parameter is 0. 003125; If the X and Y axes are rack drives and the Z axes are screw drives, the motor parameters of the X and y axes are 0. 0098175, Z axis parameters are determined according to the lead of the lead screw. If the lead is 10, the motor parameters are 0. 00625, if the lead is 5, the motor parameter is 0. 003125. Take-off frequency: 300 z-axis maximum speed: 1000 uniaxial acceleration: 400 curve acceleration: 300