Machine installation and carving machine operation process - Engraving machine

The machine installation and machine operation process: carving machine installation warning: all the power must be under operation! ！ ！ 1, mechanical connection of subject and control box, 2, the control cable end of machine body are received on the control box. 3, the power cord plug on the manipulator in the Chinese standard 220 v ( Or 380 v) The power supply. 4, control box connected to the computer, insert the cable end of data on the control box signal input port, the other end of the plug on the computer. 5, plug the power cord end on the control box of the power, the other end is inserted in the standard 220 v power socket. 6, install the engraving knife through the collet chuck in main shaft bottom. First knife when loading in the spindle taper hole into the appropriate to the size of the collet chuck, again into the chuck of the hole, the cutting tool with random little wrench stuck spindle neck flat slot, cannot turn, with a large wrench counterclockwise the spindle nut, firmly on the cutting tool. 1 2: carving machine operation process, layout, according to customer requirements and design requirements in after calculating the path, right to save different tool path. Save into different files. 2, after check the path right path file open in carving machine control system ( A preview) 。 3, fixed good materials, good working definition of the origin. Open the spindle motor right number the better. 4. Connected to the power supply for machine operation. 1 the phone is switched on. Turn on the power switch, power indicator, the machine first to run the reset self-checking, X, Y, Z, shaft back to zero, then their run to the initial standby position ( The machine initial origin) 。 2. Using a handheld controller, respectively to adjust the X, Y, Z axis, aim at carving work starting point ( Processing the origin) 。 For spindle speed, feed rate, respectively, for the choice of appropriate, make engraving machine work waiting state. 1 carving. Edit what to carving file. 2. Open the transfer files, transfer files to the engraving machine, carving work can be done automatically file. After the end when carving documents, opportunity automatically carried knives, carving and run to work above the starting point