Engraving machine how to clean the table

Carving machine face with long time is very easy to cause burrs, so, when we were in sculpt can easily lead to board, very prone to take knife carving, carved out so the patterns of the burr, and it's easy to mistake plate carved directly, so the appropriate cleaning mesa is necessary, so the mesa woodworking engraving machine how to cleaning? Let small make up to tell you.


just do the size of mesa rectangular bottom path graph, depth is not deep. The key point is the knife on the table when you need to find the lowest. Is to manually go more for a while, see where do not, at the lowest point Z origin. Overlap rate is higher, so the mesa wash out more flat and level.


method is very simple: mesa commonly used PVC board ( Snow, board) Do bottom, draw a in the software and the size of mesa is apart from the form, and then wash the bottom 2 d, and the usual wash double color plate. In a coarse a little twist blade, wash up quickly. Under the knife depth according to the case may be, is basically a deep bottom where no concave is preferred. After washing clean with respect to OK.


method 2: with special end of the qing dao, cutter diameter 6 mm, 25 mm wide, blade price 50 yuan, milling snow, super fast, of effect is also OK.


find machine mesa low then knife under 0. 5 - 1 mm deep and start the shaft manually run back and forth, note: depending on the mesa material choice of different feeding speed.