Engraving machine common problems and solutions

A dislocation, sculpture in 1, the speed is too fast parameter is set correctly 2, whether there is static or external interference, whether or not there are earthed 3, check the machine tool spindle lubrication, boot no reaction, machine no electricity, the handle has no reaction, don't show 1, changing in the computer case 2 d macro card slot position to install software and DSP controller within the data cable is there a needle and 3, check the control in the power supply output current, circuit is correct in a patch panel air plug is connected properly 4 drives the electric switch insurance tube rectifier is damaged 4, X Y Z axis motor when the bridge wire mother bearing movement is concentric with and without any card phenomenon. 5, the drive current is too small, the drive motor or damaged. Third, the party not party, circle is not round, sawtooth workers do shake 1, adjust the engraving machine each axle housings silk mother motor 3 concentricity firmness. 2, adjust the parallel machine tool, check the slider, motor belts, shafts, pine is no damage to four, vacuum pump don't turn without suction or inversion of 1, 2, water circulating pump motor line voltage is normal whether water is little, motor is stuck living removed rust or pipe network fan rotation axis of 3, mesa filter blocked in the phenomenon of leak repair 4, vacuum pump clean up 5, and positive &negative switching on the motor U V W any two lines to change the direction of motor. Five, the increasingly deep or shallow machine tool touch in engraving sample two-tone 1 used plank, mesa whether level off is smooth 2, if there is a gap of 3 shafts, too much interference filter, magnetic ring to prevent interference with six, machine tool is not zero after processing the closed don't work back to the origin, 1 d macro card is damaged, if 2 limited position switch, limit switch is damaged within 3, DSP controller parameter is properly 4, check the mapping file problem after 5, carving the closed d macro press F7 DSP press confirm to see if can return to the origin seven, sculpture, size error is 1, the pulse equivalent incorrect modify parameters, two compression carving material to prevent loosening three, screw shafts have clearance adjusting 4, file design transformation problems in eight, rotating speed of the spindle can not meet the specified 1, check the inverter and the wiring board on line is correct, 2 d macro card cable wiring board damage parameters in the DSP controller is not correct to reset 3, to adjust the frequency converter internal parameters of nine, to or longitudinal are run in the direction of a 1, 2, loose cable 3 d macro damage, 4 d macros or handle wiring board damaged, loose drive circuit or wrong wiring