Engraving machine carved words, not smooth, design fuzzy what reason be - 【 】 Engraving machine _ _ _ _ CNC woodworking engraving machine engraving machine carving factory

sculpture in words, not smooth, you can refer to the following reasons:





1, carving machine y or x axis clearance may also have clearance, two axis at the same time, cause shaking in the process of carving carving path deviation cause lettering is not smooth;



2, carving machine leads to huge difference between linear velocity and speed curve engraving machine in shock when go curve ambassador carving path deviation and appear lettering is not smooth. How does the corresponding to solve?



3, check the carving path if there is a problem, we do this in our practical experience in has a lot to do, what kind of font should choose what kind of Angle of cutting tool, how much of a word generally engraving depth in how much, and so on. These will need to actual operation to familiar with.



4, whether serious wear, tool wear more serious when will make carved font fuzzy not clear. Tool commonly used in its life about two-thirds of the time you should consider changing knife or a knife.





the first reason if engraving machine is a circle will think of some way to change guide or slider, action will be big, depending on the reason. If need to adjust the up and down or side rail is simpler to before and after the slider can be;



if a straight line or curve is the second reason that is about to change, change the value in carving machine parameters to determine.



if none of the above problems, it should consider the machine's hardware problem. Stone carving machine like rack drive, if you have any clearance rack above too much clutter, the spindle will cause deformation or fuzzy machine carved.





engraving machine carving patterns in the process of carving is not smooth, especially rough what reason be?





in the first place is a reason why engraving machine engraving when action is larger, a second reason is that the orbit of engraving machine configuration is a circular orbit, Suggestions for square rail. Of course it all depends on the reason. If my machine is in itself of the orbit that is very simple, only need to adjust the up and down and around the slider, and suggested that the machine must use original imported rail and sliding block





laser engraving machine engraving shades?





we first compare whether the following reasons, then according to the following solution to check yourself.





1. The cause of the problem: the focal length is not allowed.


solution: focus again.





2. The cause of the problem: laser tube work abnormal


solution: replace the laser tube.





3. The cause of the problem: to laser beam.


solution: check the adjustment of laser beam.





4. The cause of the problem: the laser system is dirty.


the solution: clean all optical components, guide rail, bearing and belt.





5. The cause of the problem: the material is not horizontal or thickness is inconsistent.


solution: check the focal length of the different location, use the thickness of the more consistent material





6. The cause of the problem: air booster conical parts direction deviation ( With air booster model) 。


solution: check and adjust the direction of this widget is accurate.





7. The cause of the problem: the platform level.


solution: use tools focus, on the platform of the four Angle of focal length measurement. Difference in height between the platform should be + / - 0. Within 20 inches. If you need to adjust.





fault solution can be seen from the above, laser engraving machine maintenance is focus lens and laser tube. Both problems can be caused by laser engraving machine breakdown. Of course, before use must pay attention to the change of the focal length.