Cutting machine parts maintenance and the maintenance rule

The maintenance content is as follows: 1, cutting machine Laser oil 1) Weekly check the tank oil level, such as laser system should also check after repair, oil level is lower than the oil window should include laser oil; 2) This machine is used for laser for ISO HM46 or MOBIL oil DTE25; 3) New work 2000 hours after the oil should be replaced, planing machine after every work of 4000 ~ 6000 hours after the oil should be replaced, oil change every time, should be cleaning tank; 4) System oil temperature should be between 35 ℃ ~ 60 ℃, shall not exceed 70 ℃, such as too high will lead to damage of metamorphic oil and accessories. 3, cutting machine Filter 1) Every time an oil change, filter should be replaced or cleaned thoroughly; 2) Associated with the machine alarm or clean oil filter and other abnormal, should be replaced; 3) Tank on the air filter, clean every three months to check, good 1 year replacement. 2, cutting machine 1) laser department Clean the laser parts (every month Base board, valve, motor, pump, tubing, etc. ) , prevent dirt from entering the system, cannot use cleaner; 2) Phone use after a month, check whether there is any deformation on the oil pipe bend, if there is any exception should be replaced, use two months later, should tighten the joint of all parts, for the work should be shut down, when the system pressure. Cutting machine parts maintenance and the maintenance rule before cutting machine maintenance or brush machine, should turn off the upper die alignment after lower die down, until the work is completed, if you need to boot, or any other manipulation, should will choose in manual mode, and to ensure safety.









launch confession word laser cutting machine